After the pour. Aluminum, like any heavy metal will recycle 100% (save the stuff still stuck in the crucible). The ingots are perfectly size for the crucible. Once I get my first foam carving done I can just throw these in and re-melt them.
Duration : 0:0:39
DON’T TRY THIS AT HOME!!! The hair dryer was enough to heat aluminum cans but not aluminum rods. I switched to an air compressor to push more air in and it definitely did the trick. Even though I was wearing safety glasses, a hot ember managed to get under them and burn off three of my eye lashes.
Duration : 0:0:28
DON’T TRY THIS AT HOME!!!!! An overview of my aluminum foundry. Only cost me about $30 bucks at Ace Hardware. Got some scrap aluminum at a welding yard for free and tried to mold them into ingots using a wal-mart muffin pan.
Duration : 0:2:5
Instructable video using readily available tools and materials in the kitchen, in order to cast pewter metal. A mix of salt, water and flour is used instead of sand. Entire process carried out in the kitchen.
Duration : 0:10:58
Investment casting, rapid prototyping, sand casting, patternmaking, tool making, production machining, cmm inspection and quality standards.
http://www.awbell.com.au
http://www.rapidparts.com.au
A.W.Bell Pty Ltd
145 Abbotts Road
Dandenong South 3175
Australia
P: +61 3 97999 555
F: +61 3 97999 666
E: sales@awbell.com.au
Duration : 0:8:30
A video I put together of my brother pouring bronze at Red Deer College in Alberta.
Duration : 0:6:13
In part one I made the sand mould. Now I melt metal and complete the casting.
Duration : 0:7:43
http://www.manufacturinget.com/
This was a laboratory assignment for the course METH 4571 at the University of Memphis, Department of Engineering Technology.
Duration : 0:3:29
The first video in my 11 part series showing how I make alloy castings in my home made foundry.
Part one shows how the mould is made and in part two the metal is melted and poured.
Duration : 0:9:58
Pouring molten aluminum